
Menu
Menu
Menu
Menu

Menu
Menu

Nachi Direction Control Valve
Nachi Right Angle Check Valve In-line Check Valve

- The right angle type check valve changes the flow direction of fluid 90 degrees, while the in-line check valve allows only axial direction flow.
- The cracking pressures of these valves are fixed, so fluid passes freely in one direction, but is restricted from flowing in the opposite direction.
Nachi Pilot Check Valves

- Normally, fluid is allowed to flow in a single direction, just as with a standard check valve. Reverse flow can be enabled, however, when the check valve is pushed upwards by external pilot pressure
- Very compact configuration.
Nachi Gauge Cock

- Ultra-compact configuration requires minimal installation space.
- Intelligent design packs plenty of function into a simple configuration.
- Maximum operating pressure of 35MPa{357kgf/cm²} allows operation across a wide range.
Nachi DMA Type Manual Valve

- The compact 01 and 03 sizes are perfect for small flow rate control.
- Since a balanced type valve is used, there is no need for drain piping, and use with back pressures up to 16MPa (163kgf/cm²) is possible.
- Mounting methods are the same as SAG01/03, and the 01, 03 size modular valve can be used, so circuit configuration is quick and easy.
Nachi Flange Type Check Valve/Throttle Valve Pilot Operated Check Valve

- This series provides high capacity and flange connection, as well as compliance with new standards and Japan Oil Hydraulic Standards (JOHS).
- Measurable higher pressure and higher capacity than previous models.